Maytag mat12psa Manual De Usuario

16

16022842  Rev. 0

©2003 Maytag Appliances Company

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

1.  Disconnect power supply to unit.
2. Use key to gain access through service door.
3. Remove screw securing timer bracket to meter case.
4. Lift timer and bracket up and forward from the meter

case.

Extra wire (slack) can be fed from the left.

1. Disconnect power supply to unit.
2. Remove top two T-20H Torx  screws located on the

front of the control panel.

3. Carefully lay  the control panel forwards.
 Note: Use a protective cloth to minimize the chance

of scratching the panel on the control console.

1. Disconnect power supply to unit.
2. Remove Control Panel.
3. Remove four 5/16” nuts from backup plate mounting

studs.

4. Lift board from studs and tilt forward.  Don’t lose the

spacers.

5. Disconnect touch pad ribbon.  Grasp touch pad “tail”

between your thumbs and forefinger.  Ribbon can be
pulled out of receptacle.

5. Squeeze tabs to remove connectors from timer.

1. Disconnect power supply to unit.
2. Carefully pry the timer knob center cap out of the

knob.

3. Slip the retainer clip off of the timer shaft.

4. Pull the knob, spring and dial off of the timer shaft.
5. Remove screws securing Timer to Control Panel.
6. Remove Control Panel.