Maytag mat12psa Manual De Usuario

©2003 Maytag Appliances Company

16022842  Rev. 0

27

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

6. Set washer down on top of the wood block.
7. The complete assembly of the Tubs and Damper

should be pushed up from the base far enough to get
to the damper pads.

8. Scrape old pads from base.
9. Use a degreasing agent such as alcohol to remove

any grease from the area.

10.Apply rubber adhesive to area where old pads were

removed.

11. Apply pads to base and let dry.  The top surface of the

pad should be located 3/32” below center opening in
base.  The distance between pads should be about
5/8”.

1. Disconnect power supply to unit.
2. Put Tub Block in Tub and lay washer back far enough

to get to the Pulley and Brake Package.

3. Remove Bolt and Retainer Clip in Damper holding the

brake package.

Bolt and Retainer Clip must be removed before

the brake package.

1. Disconnect power supply to unit.
2. Remove two bolts holding Top Cover and raise.
Note:

Tape Lid to prevent it from striking the Control

Panel.

3. Remove nut from three eyebolts.  The position of the

nuts on the eyebolts can be marked by placing strips
of electrical tape around bolts above nuts before
loosening.

4. Remove Drive Belts.
5. Tip washer back and lay 4” X 4” wood block under

drive pulley.

pressed into the center tube of the transmission.

3. Slide assembly over square thread of center shaft until

the Lip Seal starts into the center tube bore.

4. Turn Drive Pulley onto the center shaft and against

Seal -protector.  Tighten pulley to press Lip Seal into /
center tube bore.  Back pulley off and check to make
sure Lip Seal is pressed into position (flange of Lip
Seal should be against end of center tube).

5. Remove Pulley.
6. Using the loops, remove Seal -Protector and discard.

7. Replace pulley and belts.  Be sure rotor bearing is on

drive pulley correctly with “cup” of bearing over hub of
pulley.

8. Place washer in upright Position.  Replace front panel

and remove tub block.

Connect washer and check for proper operation.