Metra Electronics 99-7413 Manual De Usuario

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Remove 
the shifter cover and (4) Phillips screws 
exposed.  Remove (2) screws from the 
driver's side knee bolster and lower.  
Remove (1) screw from the left corner of the  
radio triim bezel.  Remove (2) screws above 
the radio opening and unclip the bezel.  
Remove (4) screws from the factory head 
unit assembly and disconnect the wiring.

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Unclip 
the gear shifter trim bezel and remove (2) 
Phillips screws exposed.  Remove (2) 
Phillips screws above the radio opening.  
Unclip the radio trim bezel.  Remove (4) 
Phillips screws from the factory head unit 
and disconnect the wiring.

Using the raised lines as a guide, cut and 
remove the ends of each Mounting Bracket 
("A").   

Locate the corner of each lower mounting 
tab on the Mounting Brackets ("A").   

Using the corner of each mounting tab as a 
guide, cut and remove the ends of the 
cupholder mounts from the Mounting 
Brackets 

("B").   

Align the holes in the Mounting Brackets 
with the holes in the Radio Housing and 
mount with (6) #6 Self-tapping Screws 
supplied.

Remove (4) screws securing the cupholder 
to the factory head unit assembly and 
remove.  Slide the cupholder into the bottom 
of the Radio Housing and mount with the 
same (4) screws.   Skip to the Installation 
Instructions for ALL VEHICLES on Page #3.

NISSAN Altima  1993-97

NISSAN Altima  1998-01

Align the OUTER holes in the Mounting 
Brackets with the holes in the Radio 
Housing and mount with (6) #6 Self-
tapping Screws supplied.  (The Brackets 
will mount on an angle).   Skip to the 
Installation Instructions for ALL VEHICLES 
on Page #3.