Viper 5002 Manual De Usuario
©
2006
Directed Electronics
7
➤
➤
V
Vaalliiddiittyy:: Output that will send a signal as long as the transmission is received.
➤
➤
LLaattcchheedd:: Output that will send a signal when the Channel 6 button(s) is pressed and will
continue until the same button(s) is pressed again.
continue until the same button(s) is pressed again.
➤
➤
LLaattcchheedd,, rreesseett w
wiitthh iiggnniittiioonn:: Similar to the latched output, this type of output turns on the first
time the Channel 6 button(s) is pressed and turns off the next time the same button is pressed.
This type of output additionally stops and resets whenever the ignition is turned on and then off.
This type of output additionally stops and resets whenever the ignition is turned on and then off.
➤
➤
3300--sseeccoonndd ((6600,, 9900)) ttiim
meedd:: Output that will send a continuous signal for 30 seconds. The
Bitwriter
TM
can program from 1 to 90 seconds.
H2/5 WHITE/BLACK (-) channel 5 output
See H2/4 description.
H2/6 VIOLET/BLACK (-) channel 4 output
See H2/4 description.
H2/7 LIGHT BROWN (-) horn honk output (200mA)
This wire is a low current output (200mA) for the horn to sound. It can be programmed to sound
only during full trigger or to be used like a siren output with arm/disarm chirps. Refer to System
Features Menus #3, feature #2 in the manual for additional information.
H2/8 LIGHT GREEN/BLACK (-) factory disarm output
This wire sends a negative pulse every time the alarm is disarmed or the optional remote start is
activated. This can be used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a
relay to send a (-) or (+) pulse to the disarm wire as shown in the diagrams below. This also outputs
with CH2 is activated. This function is programmable ON/OFF.
activated. This can be used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a
relay to send a (-) or (+) pulse to the disarm wire as shown in the diagrams below. This also outputs
with CH2 is activated. This function is programmable ON/OFF.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.