ClearOne comm converge pro 880 Manual De Usuario

Descargar
Página de 2
Audio Performance
Conditions: Unless otherwise specified, all  
      measurements are performed with a 20 Hz    
      to 22 kHz BW limit (no weighting)
Frequency Response: 20 Hz to 22 kHz ±1dB
Noise (EIN): -126 dBu, 20 kHz BW, max gain, 
      Rs=150 Ω
THD+N: <0.02%
Dynamic Range: 100 dB (non A-weighted)
Crosstalk <-91 dB re 20 dBu @ 20 kHz channel 
      to channel
Auto Mixer Parameters
     Number of Open Microphones (NOM)
     PA Adaptive Mode
     First Mic Priority Mode
     Last Mic Mode
     Maximum # of Mics Mode
     Ambient Level
     Gate Threshold Adjust
     Off Attenuation Adjust
     Hold Time
     Decay Rate
Matrix Mixing Parameters
12 analog in/out
18 expansion bus in/out
8 assignable processing blocks in/out
4 assignable fader blocks in/out
Assignable Processing Blocks
     Filters:
          All pass
          Low pass
          High pass
          Low shelving
          High shelving
          Parametric EQ
          Notch
          CD Horn
     Crossovers:
          Bessel
          Butterworth
          Linkwitz-Riley
     Compressor
     Delay; adjustable up to 250 ms
Assignable Fader Blocks
     Gain/Mute
Microphone Input Configuration
     Input Gain Adjust
     Mic or Line Level
     Phantom Power on/off
     Echo Cancellation on/off
     Noise Cancellation on/off
     Filters:
          All Pass
          Low Pass
          High Pass
          Notch
          PEQ
     Mute on/off
     Chairman Override on/off
     AGC on/off
     Automatic Level Control on/off
     Auto Gate/Manual gate
     Adaptive Ambient on/off
     Pre AEC channel
Mic/Line Inputs 1-8
     Push-on mini-terminal block, balanced,   
          bridging
     Impedance: < 5 KΩ
     Nominal Level: adjustable -56 dBu to 0 dBu   
          (7 dB step coarse gain adjustment)
     Maximum Level: -65 dBu to +20 dBu
     Echo Cancellation: 130 ms tail time (works   
          with 12 dB of room gain)
     Noise Cancellation: 6–15 dB attenuation
     Phantom Power: 24 V, selectable
Line Inputs 9-12
     Push-on mini-terminal block, balanced,   
          bridging
     Impedance: < 5 KΩ
     Nominal Level: 0 dBu
     Maximum Level: 20 dBu
Outputs 1-12
     Push-on mini-terminal block, balanced
     Impedance: < 50 Ω
     Nominal Level: 0 dBu
     Maximum Level: 20 dBu
Expansion Bus In/Out
     Proprietary Network
     RJ-45 (2), 1.9 Mbps
     Category 5 twisted-pair cable, 200’ maximum   
          cable length between any two Converge  
          Pro devices
Ethernet
     Autoswitching with Quality of Connection   
          (QoC)
     10/100 Mbps Ethernet Network Port
     10/100 Mbps Ethernet PC Port
      RJ-45 Connectors
RS-232
     Serial Command Protocol Only (Console   
          software not supported on RS- 232 port)
     DB-9 female
     9,600/19,200/38,400/57,600/115,200 baud   
          rate; 8 bits,1 stop bit, no parity
     Hardware flow control on (default)/off
USB
     Version 2.0 Compatible
     Type: B-connector
Control/Status Ports
     DB-25 female A/B (2)
     Inputs A/B: active low (pull to ground)
     Outputs A/B: open collector, 40 VDC max,   
          40 mA each
     +3.3 VDC pins (2) (300 mA over-current   
          protected)
Configuration & Administration Software
     Converge™ Console
Power Input Range
     Auto-Adjusting
     100–240 VAC; 50/60 Hz
Power Consumption
     30 W Typical
Dimensions (L x D x H)
     17.25” x 10.25” x 1.75”
     43.8 x 26 x 4.5 cm
Weight
     7.5 lbs/3.3375 kg unit weight
     12 lbs/5.4kg shipping weight
Operating Temperature
     14° F/-10 °C to 122° F/50° C ambient unit   
          temperature
Approvals & Compliance
     AES48-2005: AES standard on   
          interconnections — Grounding and 
          EMC practices — Shields of connectors   
          in audio equipment containing active   
          circuitry (self certified)
     U.S.A. & Canada
          CSA safety listed
     EU Countries
           RoHS compliant
          WEEE compliant
     See product manual for additional details
Optional Accessories
     Converge Pro 880
     Converge Pro 880T
     Converge Pro 840T
     Converge Pro 8i
     Converge Pro TH20
     Converge Pro 880TA
     Converge SR 1212A
     Converge SR 1212
     Tabletop Controller
     
Part Number
     910-151-880 Converge Pro 880 – 8-channel   
          AEC Microphone Mixer
CONVERGE™
 
PRO 880 
DATA SHEET 
<
>     
CONVERGE
  
PRO 880 BACK PANEL
>     
SPECIFICATIONS
>     
CLEARONE LOCATIONS
Headquarters:
Salt Lake City, UT USA
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Tel: 801-975-7200
Toll Free: 800-945-7730
Fax: 801-977-0087
sales@clearone.com
Latin America
Tel: 801-974-3621
global@clearone.com
EMEA
Tel: 44 (0) 1189 036 053
global@clearone.com
APAC
Tel: 801-303-3388
global@clearone.com
© 2009 ClearOne Communications, Inc. All rights reserved. Information in this document is subject to change without notice. Other product names may be registered trademarks of their respective owners who do not necessarily endorse ClearOne 
or ClearOne’s products in the United States and/or other countries.
ClearOne Document: 802-151-880 Revision 1.5 April 2009.