Metra Electronics 99-7892 Manual De Usuario
3
8
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(4) screws from the lower portion of the
center console. Remove the gear shifter
knob and lift the console out. Remove the
ashtray and ashtray bracket. Remove (2)
screws from the bottom of the head unit
support, slide the unit out and disconnect the
wiring.
prevent an accidental short circuit. Remove
(4) screws from the lower portion of the
center console. Remove the gear shifter
knob and lift the console out. Remove the
ashtray and ashtray bracket. Remove (2)
screws from the bottom of the head unit
support, slide the unit out and disconnect the
wiring.
1
HONDA Accord 1990-93
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the cover cap located under the emergency
brake and remove (2) screws exposed.
Remove (2) screws from the rear corners of
the lower dash trim bezel and remove.
Remove the ashtray and (2) screws
exposed. Unsnap the ashtray housing and
disconnect the cigarette lighter harness.
Remove the gear shifter knob and unsnap
the shifter trim. Remove (2) screws below
the radio opening and remove the upper
dash trim bezel. Remove (2) 8mm screws
securing the factory head unit and
disconnect the wiring.
prevent an accidental short circuit. Remove
the cover cap located under the emergency
brake and remove (2) screws exposed.
Remove (2) screws from the rear corners of
the lower dash trim bezel and remove.
Remove the ashtray and (2) screws
exposed. Unsnap the ashtray housing and
disconnect the cigarette lighter harness.
Remove the gear shifter knob and unsnap
the shifter trim. Remove (2) screws below
the radio opening and remove the upper
dash trim bezel. Remove (2) 8mm screws
securing the factory head unit and
disconnect the wiring.
1
ACURA Integra 1994-00
2
Cut and remove the TOP clips from the
Radio Housing.
Radio Housing.
Cut and remove the TOP clips from the
Radio Housing.
Radio Housing.
ISO-DIN HEAD UNITS: Mount the Rear Support Bracket to the back of the pocket with (2)
Phillips Screws supplied. Skip to the Installation Instructions for ALL VEHICLES on Page
#11.
Phillips Screws supplied. Skip to the Installation Instructions for ALL VEHICLES on Page
#11.
ISO-DIN HEAD UNITS: Mount the Rear Support Bracket to the back of the pocket with (2)
Phillips Screws supplied. Skip to the Installation Instructions for ALL VEHICLES on Page
#11.
Phillips Screws supplied. Skip to the Installation Instructions for ALL VEHICLES on Page
#11.
3
3