Mitsubishi diamond plus 200 Manual De Usuario

- 12 -

(8) USB Monitor Control will be available when installing

"USB Monitor Control Software" into the computer.
The "USB Monitor Control Software" can be down-
loaded from Mitsubishi Internet Home Page:

You can confirm that Enumeration of Mitsubishi Monitor
Function is successfull with the following method.

•

Open “Device Manager” tab in “System” property

under “Control Panel”. Confirm that “HID-compliant
Device” and “USB Human Interface Device” are listed
in “Human Interface Device”. If you can’t confirm it, re-
enumerate “Mitsubishi Monitor Function” again by
following (a) or (b).

(a) Disconnect and connect the USB cable to the up-

stream port of the display monitor.

(b) Cycle power of  the display monitor off then on.

If  the mark       appears with “HID-Compliant Device”
and/or “USB Human Interface Device”, the enumera-
tion was unsuccessful.  Select “HID-Compliant Device
“and/or “USB Human Interface Device marked with

  mark and click “Remove” and “Refresh”.  After

that, the enumeration is automatically started.

Figure 12

Figure 13

The following should be observed in order to use the USB
function reliably:

•

Make sure the connection is made firmly and correctly.

•

Close all Windows program before changing the Up-

stream port or disconnecting USB cable.

Generic USB Hub