GE PT878GC Manual De Usuario
Programming Site Data
4-35
April 2004
Entering General-Purpose Analog Inputs (cont.)
2. The next prompt asks you to create a label for the input. The
label corresponds to the measurement type (i.e., velocity or
temperature), while the units symbol corresponds to the
measurement units (i.e., feet/sec or degrees F).
temperature), while the units symbol corresponds to the
measurement units (i.e., feet/sec or degrees F).
a. Press
[ENTER]
to open the text creation window, which
appears similar to Figure 4-16 below.
Figure 4-16: The Text Creation Window
b. Use the four arrow keys to scroll to the desired letter or
symbol, and press
[ENTER]
to add the letter to the label.
Note: Pressing
[SEL]
causes the screen to alternate between a
set of upper-case (capital) letters, a set of lower-case
letters, and a set of symbols. Use all three screens to
create a desired label.
letters, and a set of symbols. Use all three screens to
create a desired label.
c. Repeat this procedure for each letter or symbol you wish to
add to the label. If you wish to delete a letter, press
[F1]
(Delete) to erase each letter or symbol, from right to left on
the label. (The label window can display up to 14
characters.)
the label. (The label window can display up to 14
characters.)
d. When you have completed the label, press
[F3]
(OK) to
confirm the label, or
[F2]
(Cancel) to leave the window
without adding the label.
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 . , “ ‘
= < >
Delete
Cancel
OK