Garmin gpsmap 182c Manual De Usuario

67

Alarm Tab— allow you to defi ne the alarm settings. The Alarm tab is divided into three submenu 
tabs: System alarms, Nav alarms and Sonar alarms.

System Tab: 
 •   Clock— provides an alarm for the system clock. Enter a time in the time fi eld and turn the alarm on 

and off from the control fi eld menu. Remember to enter alarm times in the same time format (UTC 

or local) you’re using for your system. The unit must be on for the clock alarm to work.

•    Battery— sets an alarm to sound when the battery is reaching a critical state of discharge.
•    DGPS and Accuracy— DGPS alarm will sound when the unit loses a differential fi x. The accuracy 

alarm will sound when the GPS position accuracy falls outside the user-set value.

Nav Tab: 
•    Anchor Drag— sets an alarm to sound when you’ve exceeded a specifi ed drift distance. Enter a value 

in the distance fi eld and use the control fi eld to turn the alarm on and off.

•    Arrival— sets an alarm to sound when you’re a specifi ed distance or time away from a destination 

waypoint. Enter a distance radius or time for sounding the alarm and use the control fi eld to set the 

alarm to ‘Off’, ‘Dist’ (Distance), or ‘Time’. 

•    Off Course— sets an alarm to sound when you’re off a desired course by a specifi ed distance. Enter 

a distance in the distance fi eld and use the control fi eld to turn the off course alarm on and off.

Sonar Tab: (You must be receiving sonar NMEA data (pg. 87) for these functions to work.
•    Shallow Water/Deep Water— set alarms to sound when you enter an area of specifi ed depth that is 

too shallow and/or too deep. Enter a depth in the distance fi elds and use the control fi elds to turn 

the alarms on and off.

• Water Temperature — sets an alarm to sound when the transducer reports a temperature either 

above, below, inside or outside the specifi ed values. 

• Fish — sets alarm to sound when unit detects a fi sh of the specifi ed symbol size.

1.   Use the ARROW KEYPAD to highlight desired submenu tab of the Alarm Tab.
2.   Highlight the fi eld below the alarm name you wish activate and press ENTER/MARK.
3.   Change the mode to the desired setting and press ENTER/MARK.
4.   Highlight the next fi eld to the right and press ENTER/MARK, then enter the desired settings and 

press ENTER/MARK to fi nish.

5.   If you want the alarm to display and beep until acknowledged, highlight the ‘Persist’ box and press

     ENTER/MARK to place a check mark in the box.

182C Manual Part 2.indd   67

6/4/2003, 2:54:21 PM