Viewsonic PJ1165 Manual De Usuario

• Replace the batteries whenever the remote control starts to malfunction.
• When strong lights, such as direct sunlight or light from an extremely close range (such 

as from an inverter fluorescent lamp), hit the projector’s remote sensor, the remote 

control may cause to function. Adjust the direction of the projector to keep light from 

directly hitting the projector’s remote sensor.

The remote control works with the 

projector’s remote sensors.
Front remote sensor is 3 meters with a 

60 degree range (30 degrees to the left 

and right of a remote sensor).
Rear remote sensor is 3 meters with a 4 

degree range (2 degrees to the left and 

right of a remote sensor).

Also a remote signal reflected in the screen etc. may be available. If it is difficult to send a 

remote signal to the sensor directly, please try.
Since the remote control uses infrared light to send signals to the projector (Class 1 LED), 

be sure to use the remote control in an area free from obstacles that could block the remote 

control’s output signal to the projector.

You can use the remote control as a wired remote control, by connecting the REMOTE 

CONTROL port of the main unit and remote control via an audio cable (3.5 dia. Stereo mini 

cable with plugs).

This is the function to properly use when you use two or three same type 

projectors at the same time. This function should be used combining a 

setup of a projector.

Set the ID number to the projector beforehand, refer ring to the item “IR 
REMOTE ID” of the section “OPTION Menu”.

When the ALL is selected to the item “IR REMOTE ID” of the 

OPTION menu, the projector is controlled by a remote control 

irrespective of the position of the ID CHAGE switch.

Slide the knob of the switch into the position of the ID number of the 
projector you want to control.

 

• Do not disassemble the remote control.
• Do not place the remote control near the projector’s lens, fan, or vents.
• Do not drop or other wise expose the remote control to physical impact.
• Do not get the remote control wet or place objects. Doing so may result in malfunction.
• Remove the batteries from the remote control and store them in a safe place if you 

won’t be using the remote control for an extended period.

approximately 
3 meters

approximately 
3 meters

ID CHANGE 
switch