GE 28320 Manual De Usuario

Handset Registration

Accessory Handset (Purchased

Separately)

For accessory handsets (without Base unit), an

auto-registration mechanism is available so the

unregistered accessory handset can be automatically

registered without the need of entering a PIN code.

On the base:
1. Put the base into subscription mode, by pressing

and holding the PAGE button for at least 8 seconds.

2. The DECT indicator light starts flashing. It is now

ready to be associated with a new handset. This

registration mode lasts 90 seconds after pressing

the button. Once the subscription is done, the base

LED flashing is switched off.

On the handset:
1. Make sure your phone is

OFF (not in talk mode).

2. Press

, navigate to the

Registration menu, press

to enter.

3. Use

to scroll to

Register Handset.

4. Press

to enter the menu and start the handset

registration.

Wait Base searching 1”is displayed.

If the handset has located the base, it may

display (depending on EEPROM settings), the base

identification number (RFPI).

Handset Registered is displayed and the handset

goes back to idle.

6. The DECT indicator light on the Base stops flashing

when a handset has successfully been registered.

If the handset does not locate the base, it goes back to

idle mode. Try again.
If the handset emits a double beep, it means that

the base has reached the maximum number of 5

subscribed handsets.

Auto-registration;

Handsets packed with

the base unit are pre-

registered and ready to use

right out-of-the-box.

NOTE: When a handset is

associated with a base,

a number is given to the

handset by the base. This

number is displayed on the

handset after the name

and must be used for

internal calls.

NOTE: A handset can be

registered to only one

base.