Zoom 2020 Manual De Usuario

This LED lights up when the 2020 is in the Edit (Manual)
mode. 

Lit LED indicates which effect module in the current
patch is ON. 

Lit LED indicates which effect module in the currently
edited patch is ON, and flashing LED indicates the
currently edited effect module. 

Flashing LED indicates the currently edited parameter in
Edit mode. 

Selects the next higher bank. 

Switches REVERB for the effect module on and off. The
pedal LED lights up when REVERB is on. 

The pedals serve to select a patch. The respective pedal
LED lights up. 

The pedals serve to switch the effect modules
COMP+DIST, EQ, MODULATION, DELAY on and off.
The respective pedal LED lights up. 

Serves for connection of a guitar. 

The guitar signal from the input is supplied without
alteration at this output, to allow tuning without the need for
cabling changes.  

This connector allows use of the optional foot pedal FP01 to
control the volume level of the 2020. Since the level is
adjusted between the EQ module and the MODULATION
module, the volume can be changed without affecting
reverberation. 

This jack serves for connection of the optional foot switch
FS01 or foot pedal FP01. The FS01 can be used to switch
between Play mode and Manual mode, and the FP01 can be
used to control the wah effect of the EQ effect module. 

Serves for connection to a guitar amplifier. To use the 2020
in stereo, connect cables to both jacks. For a monaural
setup, connect the cable to the L/MONO jack. 

For connection of a pair of stereo headphones. Since the
output at this jack has been processed by an amp simulator,
it can also be used as recording output for connection to a
tape recorder or mixer. 

The supplied AC adapter is connected here. To guard
against inadvertently disconnecting the adapter cable, wind
the cable once around the hook. As long as the AC adapter
is connected here, the unit is turned on. There is no separate
power switch.