ICOM ic-t3h Manual De Usuario
30
8
SCAN OPERATION
■ Programmed scan
Programmed scan repeatedly scans between two user pro-
grammed frequencies (memory channels “1A–3A” and “1b–3b”) or
scans between upper and lower band edges. This scan is useful
for checking for signals within a specific frequency range such as
repeater output frequencies, etc.
grammed frequencies (memory channels “1A–3A” and “1b–3b”) or
scans between upper and lower band edges. This scan is useful
for checking for signals within a specific frequency range such as
repeater output frequencies, etc.
q Push [D•
CLR
] to select VFO mode, if necessary.
w Push [A•
FUNC
], then push [5•
SCAN
] to start the scan, then a se-
lected scan edge appears as “P1”, “P2”, “P3” or “AL.”
• To change the scan edge, push [A•
FUNC
] then push [8•
SET
] several
times until the desired scan edge appears.
• “AL” for full scan, “P1”, “P2” and “P3” for programmed scan be-
tween the programmed scan edge channels as “1A”–“1b”,
“2A”–“2b” and “3A”–“3b”.
“2A”–“2b” and “3A”–“3b”.
• To change the scan direction, push [Y] or [Z].
• When “dial” is assigned [VOL], rotate [VOL] to change the scan di-
• When “dial” is assigned [VOL], rotate [VOL] to change the scan di-
rection. (p. 50)
e Push [D•
CLR
] to stop the scan.
NOTE: Scan edges, 1A–3A/1b–3b, must be programmed in ad-
vance.
vance.
Program them in the same manner as regular memory chan-
nels. (p. 24)
If the same frequencies are programmed into the scan edges,
programmed scan will not proceed.
programmed scan will not proceed.
IC-T3H.qxd 03.2.6 10:18 Page 30 (1,1)