ONKYO dr-s501 Manual De Usuario

28

Before connecting
• Make sure that all the connections on pages 17–27 are 

complete (the connection to a TV is required).

Note:
DVD receiver features a screen saver and an auto power 
off function. If the receiver is stopped and no button is 
pressed for 15 minutes, the screen saver starts (see 
page 65).

Plug the supplied power cord into 
the AC INLET and then into the 
power outlet on the wall.
• Do not use a power cord other than the 

one supplied with the DVD receiver. 
The power cord supplied is designed 
for use with the DVD receiver and 
should not be used with any other 
device.

• Never have the power cord discon-

nected from the DVD receiver while 
the other end is plugged into the wall 
outlet. Doing so may cause an electric 
shock. Always connect by plugging 
into the wall outlet last and disconnect 
by unplugging from the wall outlet 
first.

• Before unplugging the receiver from 

the power outlet, make sure you first 
switch it into standby.

• For the above reasons, do not plug this 

receiver into a switched power supply 
found on some amplifiers and AV 
receivers.

Press [STANDBY/ON] button on 
the DVD receiver or the remote 
controller.
Turn on your TV and select the 
input through which the DVD 
receiver is connected.
The DVD receiver turns on and the 
STANDBY indicator turns off.
• To put the DVD receiver in the standby 

mode, press [STANDBY/ON] on the 
DVD receiver, or [STANDBY/ON] on 
the remote controller.

• While the STANDBY indicator lights 

up, the DVD receiver can receive sig-
nals from the remote controller.

• Setting the [STANDBY/ON] button to 

standby does not shut off the power 
completely.

To a wall outlet