Hitachi l26a01a Manual De Usuario

 

 
 

12 

 
 

PREPARATION 

Remote Control Batteries Installation  Handling the Remote Control 

This remote control operates on 2 “AA” batteries. 

1. Open the battery compartment cover 

● Slide open the battery compartment 

cover on the backside in the direction of 
an arrow, and remove the cover. 

2.  Installing the batteries 

● Install 2 “AA” batteries (included) making 

sure the polarities match the indication 
inside the compartment. 

 

3. Close the battery compartment cover 

● Make sure of the positions to fit the 

projecting parts in the holes, and slide 
the compartment cover in the direction 
of an arrow till it clicks shut. 

Use the remote control within about 5m from front 
of the unit’s remote-control sensor and within 30 
degrees on both sides. 

 

 

 

It could cause corrosion or battery leakage and may result in physical injury and/or 
property damage including fire.   

● Never mix used and new batteries in the device.   
● Replace all the batteries in a device at the same time.   
● Remove the batteries if the remote control is not going to be used for an extended period of time.   

To avoid possible failure, read the following instructions and handle the remote control 

properly.  

●

 Do not drop or have an impact on the remote control.

   

● 

Do not spill water or any liquid on the remote control.

   

● 

Do not place the remote control on the wet object.

   

● 

Do not place the remote control under the direct sunlight or near sources of excessive heat.

 

 

Caution When Moving the Main Unit 

As this product is heavy, whenever it is moved, two people are required to transport it safely.   
When moving the unit, hold it by the top and bottom frame of the LCD screen. (See the figures below for details.)     

Holes 

Projecting parts 

Within 30 degrees 

About 3m

Within 30 degrees

About 3m

About 5m