Hitachi cmpak06 Manual De Usuario

■ Special techniques are necessary for installation of the plasma display.

Do not attempt to perform this work by yourself.

■ Request an installation specialist to install this unit.
■ This company assumes absolutely no responsibility for injuries and damages that may occur due to improper

installation and handling.

■ Please remember that if you remove the plasma display set from the wall later, you will find the screw holes

and anchor bolts for the mounting unit left on the wall. Also note that a long use of the plasma display set

may discolor the wall around it due to its heat and air flow.

◎

●

To ensure customer safety, be sure to design the installation location so that the strength is sufficient to
withstand the weight of both the plasma display and the wall-mount unit.

●

Always use at least two persons for all installations.

●

Fully tighten all of the mounting screws as specified in the installation instructions.

Thank you for purchasing the Hitachi Plasma Display Wall-mount Unit.

To ensure correct usage, please read this instruction manual thoroughly. After reading, please store this manual
in a safe place for future reference.

◎This plasma display wall-mount unit is for use only with the following model:

CMP5000WX

Bolts M8 (6)

Hung on wall unit (1)

Hexagon wrench (1)

■

Before assembly,

check to make sure that none of the parts provided are missing.

* Screws to be used for wall installation are not included. Obtain them separately.