Microboards Technology copywriter series Manual De Usuario

CWT Series                                                                   MICROBOARDS TECHNOLOGY, LLC 
 

 
 

6

     
System Setup 
 

•  Connect the power cable to the CWT Series tower and plug in to a protected power outlet 

strip or UPS power supply. 

•  Turn on power to the tower.   The system is now ready to use. 

 
   Install your CWT Series duplicator in the following environment: 

•  On a level and stable surface 

•  In a well ventilated location 

• Temperature 

and 

humidity 

• Temperature: 

5-40

° 

•  Humidity: 20-80%RH (no dew formation) 

 
    Do not install it in the following places: 

ƒ

  Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked 

by a curtain or blind.) 

ƒ

  A dusty location 

ƒ

  A place where there is a lot of vibration 

ƒ

  Near open flame 

ƒ

  A place where the temperature and humidity change drastically 

ƒ

  Near a heating device such as a heater or furnace 

ƒ

  A location where air from an air conditioner blows directly onto the unit 

ƒ

  Near a container filled with water such as a vase 

 

In winter during times of low humidity or in a location where static electricity is 

generated, use an anti-static-electricity mat or humidifier to prevent static electricity. 

 
Power supply 

ƒ

  Use house current as the power source for the unit. 

ƒ

  Do not use an outlet near a motor driven appliance (i.e. air conditioner, copying 

machine). 

ƒ

  Use an outlet with stable power supply voltages. 

ƒ

  Do not overload an outlet. Do not use a service outlet from a PCs or other office 

machine. 

ƒ

  Wire the power cord properly. 

ƒ

  Do not touch the power cord with a wet hand. 

ƒ

  Be careful not to damage the power cord. 

 

Inspect the power cord periodically. 
In the event that the power cord is damaged, replace the power cord. 

 

Be sure to use a tool such as the screwdriver to change the 115/230V Switch. 
Do not use your finger.