Hatco grmm-0399 Manual De Usuario

Form No. GRMM-0399

INSTALLATION

Screw

ALL MODELS

Glo-Ray Mini-Merchandisers are shipped with most
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit and
components enclosed.

Acrylic breath protectors shield the food while allowing
easy access to the food product. Specially designed
housings and mounting hardware make installation simple.

NOTE: Remove protective paper from acrylic surfaces
before mounting breath protector.

1. Remove the unit from the carton.

2. Remove all tape and packing materials.

LEGS

1. Carefully lay unit on its side.

WARNING

Do not lay unit on the side with the control panel or
damage to unit could occur.

2. Place a rubber foot onto each leg and install one leg

into each corner hole on base. Tighten securely.
See Figure 4.

3. Turn unit upright and position warmer in desired

location.

HATCO

CORP

ORATIO

N, Milw

aukee,

HATCO

GLO-RA

FOOD

WARM

Figure 5. Assembling - GRDW-2

Figure 4. Installing Legs

GRDW-2

1. Position front breath protector top holes with weld

studs in upper channel. Loosely fasten using cap
nuts provided. See Figure 5.

2. Secure bottom of breath protector using three 5/8"

Phillips head screws provided. Tighten top and bottom
hardware securely but do not overtighten.

3. Install the side acrylic panels using two 1-1/2"

Phillips head screws on the bottom, and two 3/8"
Phillips head screws with cap nuts on the top. Fasten
cap nuts from inside the unit.

NOTE: If necessary, loosen the “L” brackets on the
upper channel and position flush with the side panel
before installing top hardware.

4. Remove upper two screws from each side of unit.

Install sign holder using original screws.

5/8" Screw

1-1/2" Screw

3/8" Screw

“L” Bracket

Sign Holder

Cap Nut