Verilux VF03 Manual De Usuario

•  Do not operate this device near a water source to avoid electrocution.

•  Do NOT dismantle.
•  Do not use with power supply voltage other than 120 VAC.
•  Do not operate lamp in close proximity to flammable or combustible vapors,

such as aerosol spray products, or where oxygen is being administered.

• Do not cut or shorten the power cord.
• The bulb in this product contains a trace amount of mercury, a chemical

known to the state of California to cause birth defects or other reproductive 

harm. This substance may also cause injury if inhaled or ingested.

• For indoor use only.
• Always unplug lamp before performing bulb replacement or installation.
• This lamp is not for use with light dimmers, timers, motion detectors,

voltage transformers or extension cords.

• This product may cause interference with radios, cordless telephones

or devices that use a wireless remote control, such as televisions. If 

interference occurs, move the product away from the device, plug the 

product or device into a different outlet or move the lamp out of the line of 

sight of the remote control receiver.

• Unplug lamp during lightning storms or when unused for long periods.
• Do not lift the lamp by the gooseneck. The lamp should be lifted by the

shaft.

• Be very careful not to pinch any part of the cord between any metal pieces.
• Do not use solvents or cleaners containing abrasives, or ammonia based

cleaners.

• All moisture should be properly wiped away and dried prior to restoring

power.

•  Do NOT use lubricating agent in assembly; please see troubleshooting

section if you are having difficulty assembling your lamp.

•  Disconnect lamp before performing alignment activity.
• Do not block vents on ballast. Vents are necessary for proper function of the

ballast; blocking them may cause overheating of the ballast.

• Dispose of bulbs per local regulations. For more information on clean-up

and disposal, see www.lamprecycle.org.