Haier hw70-1403d Manual De Usuario

dispLAy codes

¬ power-off memory function: in case of abrupt power failure or the need to cut off the power during a program cycle, the present 
settings will be saved and the preset operation will resume when the power is on again.
Note: During the spin process, if too much foam is inspected, in order to protect the motor, the washing 
machine will eliminate the foam automatically; the motor will stop and the drain pump will drain the water 
continuously for 90 seconds. If it happens more than 3 times, the motor will stop until the end of cycle 
without spinning.

 
 

coDes

causes

 soluTions

err1

¬ Door is not properly shut.

_ shut the door properly.

err2

¬ Drainage error, water not emptied within 6 
minutes.

_ clean the filter and check the drain hose for blockage. if error 
still exists, please contact the maintenance personnel.

err3

¬ Temperature sensor not properly connected or 
damaged.

_ contact the maintenance personnel.

err4

¬ heater error (appears at the end of a cycle).

_ reduce load and then start washing again. if problem still 
exists, please contact the maintenance personnel.

err5

¬Water level not met in 8 minutes.

¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.

 _ make sure that tap is turned on, and water pressure is normal. 

if problem still exists, please contact the maintenance personnel.
_ install drain hose within 80-100 cm of height.
_ make sure the drain hose is not in water.

err6

¬  motor error.

_ contact the maintenance personnel.

err7

¬ motor error.

_ contact the maintenance personnel.

err8

¬  Water exceeds protective level.

_ contact the maintenance personnel.

end

¬ end of wash cycle. 

1:25

¬The remaining time is 1 hour 25 minutes.

19:25

¬status information:preset time for delayed operation.

unb

after the last rinsing cycle finishes,spinning fails completely due to unbalance of the laundry.