Hoyt compound-2002 Manual De Usuario
19
*Measured as Effective let-off which includes friction.
**65% AMO let-off is required for entry of trophies into the Pope &
Young Record Book.
***Remove the peg entirely on VersaCam #1
**65% AMO let-off is required for entry of trophies into the Pope &
Young Record Book.
***Remove the peg entirely on VersaCam #1
Moving the draw stop more than one position away
from those shown in the chart is not recommended.
Note:
from those shown in the chart is not recommended.
Note:
changing the draw-stop position independent of
the module to manipulate let-off will alter draw length
by approximately 3/16" for each draw-stop hole; draw
length will be shortened when changing to a lower let-
off position and lengthened in higher let-off positions.
Slight variations in peak weight (up to two pounds) may
occur when changing the InnerCam position.
by approximately 3/16" for each draw-stop hole; draw
length will be shortened when changing to a lower let-
off position and lengthened in higher let-off positions.
Slight variations in peak weight (up to two pounds) may
occur when changing the InnerCam position.
ALIGNING DUAL TRACK IDLER WHEEL
To ensure your dual track idler is functioning within
its intended rotational limit, periodically check the
idler’s built-in rotational alignment marks scribed on
the wheel as shown in the Figure on the next page. For
right-handed bows, the alignment marks should be at
the bottom of the idler on the side marked with an "S".
To ensure your dual track idler is functioning within
its intended rotational limit, periodically check the
idler’s built-in rotational alignment marks scribed on
the wheel as shown in the Figure on the next page. For
right-handed bows, the alignment marks should be at
the bottom of the idler on the side marked with an "S".
Inner-Cam
Recommended Peg Position
Module Position 80% Let-off*
65%Let-off**
A
B
C
C
D
E
F
G
H
8***
VERSACAM CHART
1
1
2
3
4
5
6
1
2
3
4
5
6
7
7