Hoshizaki FD-1001MRH(-C) Manual De Usuario

8

To ensure that the bearing inside the extruding head does not exceed the wear tolerance 
of .0", follow the instructions below.

1) Turn off the power supply. 
) Remove the panels. 
3) Remove the strap connecting the spout to the chute assembly, then remove the spout. 
4) Remove the bolt from the auger and lift off the cutter. 
5) Replace the bolt in the auger. Grasp the 

bolt at the top of the auger and move the 
auger towards you and then try to insert a 
.0" round stock or pin gauge in between 
the back side of the auger shaft and the 
bearing surface. Check several locations 
around the auger shaft. If the gauge goes 
between the shaft and the bearing at 
any point or if the bearing is scratched 
or cracked, both the top bearing in the 
extruding head and the lower bearing in the 
housing should be replaced. Instructions 
for removing the extruding head and 
housing are located later in this procedure.
Note: Replacing the bearing requires a bearing press adaptor. If one is not available, 

replace the whole extruding head and housing.

6) Remove the bolt. Replace the cutter and then the cutter bolt. 
7) Replace the spout.
8) Replace the panels in their correct positions.
9) Turn on the power supply.

1) Turn off the power supply.
) Remove the panels.
3) Remove the strap connecting the spout to the chute assembly, then remove the spout.
4) Remove the bolt and lift off the cutter. 
5) Install the new cutter and replace the bolt. 
6) Replace the spout.
7) Replace the panels in their correct positions. 
8) Turn on the power supply.

.0" Round Stock
 or Pin Gauge

Extruding 
Head

Auger