Keurig B150 Manual De Usuario
SECTION 4
Troubleshooting
18
Situation
Brewer does not
have power
Brewer will not brew
Chlorine or mineral
taste in coffee
Solution
•
Plug Brewer into an independent outlet.
•
Check to be sure that it is plugged in securely.
•
Plug into a different outlet.
•
Reset your home’s circuit breaker if necessary.
•
Make sure that the Power Switch has been
turned on and LCD Display is illuminated.
•
After placing the K-Cup
®
in the K-Cup Holder, make
sure the Handle is pushed down securely and the
LCD Control Center reads “READY TO BREW” with
LCD Control Center reads “READY TO BREW” with
the BREW Button flashing, then press the Left,
Right or BREW Button.
Right or BREW Button.
•
If the LCD Control Center indicates “ADD
WATER”, add water to the Water Reservoir or
make sure the Water Reservoir is seated properly
in its base.
make sure the Water Reservoir is seated properly
in its base.
•
If the LCD Control Center indicates “ADD WATER”
even after refilling, contact Customer Service at
1.888.CUP.BREW (287.2739).
•
The Exit Needle may be clogged (refer to page 16).
•
Consider using bottled water, filtered water
or the Keruig
®
Water Filter Starter Kit
(available at www.keurig.com).
Situation
Brewing a partial cup
The time is not
displayed on the LCD
Message Center
Brewer shuts
off or turns on
automatically
Solution
•
The Exit Needle may be clogged (refer to page 16).
•
Clean the K-Cup Holder Assembly if necessary
and rinse under faucet (refer to pages 15-16).
•
The Water Reservoir may have been removed
during brewing. Replace the Water Reservoir
and perform a water brew without a K-Cup.
and perform a water brew without a K-Cup.
•
“De-Scale” the Brewer (refer to pages 16-17 ).
•
If you have repeated the de-scale procedure on
your Brewer two times and it is still only brewing
a partial cup, contact Customer Service at
a partial cup, contact Customer Service at
1.888.CUP.BREW (287.2739).
•
The time will not be displayed on the LCD
unless you have set it. To set the clock, follow the
procedure on page 12.
procedure on page 12.
•
If power is interrupted to the Brewer, you will
need to set the clock again using the procedure
on page 12.
on page 12.
•
Check to make sure that the Auto Off timer
and/or On/Off time features have not been set. To
do this, press the MENU Button below “MENU”
and scroll through the programming options.
do this, press the MENU Button below “MENU”
and scroll through the programming options.
“OFF” should be displayed for Auto Off timer and
On/Off. If “OFF” is not displayed, follow
directions on pages 13-14 to reset.
If any problems persist, contact Customer Service at 1.888.CUP.BREW (287.2739)