Keurig B150 Manual De Usuario

SECTION 1 

 

Set-Up & First Brew

1. 

 Remove all pieces of packing tape for the 

brewer and Drip Tray. Remove the clear plastic 
film from the LCD Display. Unwrap cord and 
plug the Brewer into a grounded outlet. 

2.

  Turn the Brewer on, the Power Switch is 

located at the top left hand side of the Brewer 

on the back. The Brewer’s LCD Display will 
display the power up welcome screen (fig. 1).

3.

  Remove the Water Reservoir from Brewer 

by first removing Lid from the Water Reservoir 
then lifting the Water Reservoir straight up 
and toward the right of the Brewer (may be 
tight). Rinse the Water Reservoir thoroughly 
with fresh, clean water.

IMPORTANT: 

You cannot use your Keurig

®

 Brewer 

until it has been set up for its fi rst use.

If Brewer has been exposed to temperatures

below freezing, allow Brewer at least two hours to 
reach room temperature before brewing. A frozen 
or extremely cold Brewer will not operate.

4.

  Fill the Water Reservoir up to the 

fill mark with fresh, clean water. 
Replace the Water Reservoir on 
the Brewer making sure that 
the locking tabs engage with the 
Brewer (fig. 2). Replace Lid on 
Water Reservoir.

5.

  The Brewer will automatically fill 

the Internal Hot Water Tank with 
water and then the water will 
be heated. This will take about 
3 minutes. During the heating 
period, “HEATING PLEASE WAIT” 
will be displayed on the LCD 
Screen (fig. 3). 

6.

  Place a 10 oz. mug on the Drip Tray Plate, 

then fully raise and lower the Brewer Handle. 

The Brew Button will now be illuminated. 

Press the Brew Button to start a cleansing 
brew. NOTE: A K-Cup should not be used for 
this sequence.

7.

  When the cleansing brew is complete, the 

Brewer will go into its idle state and will be 
ready to brew your first K-Cup

®

 portion pack.

6

Welcome To The 

Keurig B150 Brewing 

System Designed 

For The K-Cup

®

 

Portion Pack

Español

Français

Heating...

Please Wait