Viper 700 esp Manual De Usuario

©

2000 Directed Electronics, Inc.

■ You can activate, or arm, the system by pressing 

on your transmitter

for one second. When the system arms, you will hear a short siren sound,
or chirp, and the parking lights will flash once. If the vehicle’s power door
locks have been connected to the system, the doors will lock.

■ To disarm the system, press 

. You will hear two chirps, and the parking

lights will flash twice. If power locks are connected to the system, the
doors will unlock. If the siren chirps either four or five times when dis-
arming, see Diagnostics section. This is called Tamper Alert.

■ NOTE: This procedure will also disarm Automatic Engine Disable (AED).
1. Open the vehicle hood and locate the siren in the engine compartment. 
2. Remove the water protective cap on the siren to expose the siren lock

switch.

3. Insert the siren key into the siren lock switch and turn to the OFF position.

The security system and the security interrupts should now disarm. To
reactive the siren, simply turn the siren key back to the ON position and
replace the water protective cap on the back of the siren. 

■ The system must be disarmed in order to enter or exit Valet

®

Mode. Turn

ignition to "run" position, then turn to "off" position. Press and release
the Valet

®

switch within 10 seconds. The status LED will light solid if you

have entered Valet

®

Mode, and it will go out if you have exited Valet

®

Mode.

■ Press and hold 

down for 1 second.

■ Press 

,  

, 

on the transmitter.

■ Press 

briefly before arming or disarming, and the confirmation

chirp(s) will be eliminated for that one operation only.

✂✂

✂ ✂