Klipsch P-37F Manual De Usuario
Page 4
Page 5
Preparing the Loudspeaker
Getting Started
Unpacking
(P-38F / P-37F)
Please follow the unpacking instructions fully and in the order shown below. These loudspeakers are
heavy! Do not lift or move these speakers by yourself. Always have someone help you.
1
3
5
4
2
Open the carton flaps
Lightly tape each flap to the box
with short pieces of tape
Remove the top packing piece
Carefully invert the carton
Lift off the carton
Lift off the center and base packing pieces
The loudspeaker is
ready for connection
• The grille box contains: one upper grille; one lower grille, (P-38F / P-37F) or one single-piece grille
(P-17B, P-27C and P-27S).
• The Accessories box for P-38F and P-37F contain: four long spikes; four short spikes; four spike col-
lars; four spike seats; one Allen wrench.
• The Accessories box for P-27C contains: two short front spikes; one short-barrel rear spike; one
long-barrel rear spike; three spike collars; three spike seats; one Allen wrench.
• The P-17B and P-27S do not have an accessory box, but do include an Allen wrench with the
owner’s manual packet.
• There is a pair of gloves located in a pocket in the side of the packing carton under the owner’s manual.
Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch
dealer and the transport contractor for action.
Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch
dealer and the transport contractor for action.
Connection Procedure:
There is a specific procedure to be followed:
• Switch off and unplug the amplifier/s and all source electronics from the mains power.
• Place both loudspeakers in the general area where you want them.
• Connect each loudspeaker following the instructions under the “connecting the loudspeakers” section of
this manual.
• Attach the spikes, following the instructions under the “finalizing the assembly” section of this manual.
• Run both sets of loudspeaker cables to the amplifier.
• Connect the amplifier.
• Finalize the position of the loudspeakers.
• Finally, fit the grilles (if desired).
• Place both loudspeakers in the general area where you want them.
• Connect each loudspeaker following the instructions under the “connecting the loudspeakers” section of
this manual.
• Attach the spikes, following the instructions under the “finalizing the assembly” section of this manual.
• Run both sets of loudspeaker cables to the amplifier.
• Connect the amplifier.
• Finalize the position of the loudspeakers.
• Finally, fit the grilles (if desired).
TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND.
TO PRESERVE THE FINISH, WHEN HANDLING YOUR SPEAKERS, USE THE GLOVES THAT ARE PROVIDED.
TO PRESERVE THE FINISH, WHEN HANDLING YOUR SPEAKERS, USE THE GLOVES THAT ARE PROVIDED.
Fitting and Removing the Grilles
The grilles are magnetically attached to the cabinet. Specially designed magnets
are housed inside the front wall of the loudspeaker, so that if you wish to operate
the loudspeaker with the grilles removed, no grille mounting hardware is visible.
This preserves the smooth lines of the loudspeaker.
are housed inside the front wall of the loudspeaker, so that if you wish to operate
the loudspeaker with the grilles removed, no grille mounting hardware is visible.
This preserves the smooth lines of the loudspeaker.
To fit the grilles: Fit the top grille first and line it up with the top and sides of the
cabinet. For the P-38F, P-37F and P-17B there is a small lip on the top of the grille
that should rest on the top of the cabinet. Now, fit the lower grille, lining up the
top of the lower grille with the bottom of the upper grille. You may now remove
the top grille if you wish. (The P-17B, P-27C and P-27S have a single one-piece
grille only.)
cabinet. For the P-38F, P-37F and P-17B there is a small lip on the top of the grille
that should rest on the top of the cabinet. Now, fit the lower grille, lining up the
top of the lower grille with the bottom of the upper grille. You may now remove
the top grille if you wish. (The P-17B, P-27C and P-27S have a single one-piece
grille only.)
Although operating the loudspeakers with the grilles on or off is a matter
of personal taste, moving or connecting the loudspeakers should always be done
with the grilles removed. Be especially careful not to touch the drive units.
of personal taste, moving or connecting the loudspeakers should always be done
with the grilles removed. Be especially careful not to touch the drive units.
What’s in the box?
Remove the Grille box
Remove the Accessories box
Remove the Owner’s manual
and gloves