Crestron 1700c-bezel Manual De Usuario
Bezel Kit
Crestron 1700C-BEZEL
Installation
Perform the following to remove the existing bezel, pushbuttons, and
supporting parts from the Series 1700 touchpanel and install the new
replacement bezel. A #1 Phillips screwdriver is required. Refer to the
illustrations that accompany the procedure.
supporting parts from the Series 1700 touchpanel and install the new
replacement bezel. A #1 Phillips screwdriver is required. Refer to the
illustrations that accompany the procedure.
1. Remove the battery and place the touchpanel face down on a
clean padded work surface.
2. Remove the four screws that secure the front bezel to the base
and return the unit to its normal position. (Use care and hold the
bezel to the rest of the panel. If the bezel separates while
rotating to its normal position, the internal parts of the panel
may spill out.)
bezel to the rest of the panel. If the bezel separates while
rotating to its normal position, the internal parts of the panel
may spill out.)
Bottom View of Battery and Screws
Battery
Screw
Screw
3. When in the normal position, lift the bezel from the touchpanel.
4. As shown in the illustration on the next page, remove the
4. As shown in the illustration on the next page, remove the
pushbuttons and the membrane switch actuators from the PCB
surface.
surface.
2
• Bezel Kit: 1700C-BEZEL
Operations & Installation Guide - DOC. 6252