Cisco Systems SFS 3504 Manual De Usuario
12
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
78-18335-01
Configuring the Cisco SFS 3504 Server Switch
Step 6
Enter the show card command to verify that the switch is operational and that the system acknowledges
the new module and has brought it online. If the output of the show card command shows the oper code
as “normal” and boot status as “success,” as shown in the example below, proceed to the next step in
configuring the switch.
the new module and has brought it online. If the output of the show card command shows the oper code
as “normal” and boot status as “success,” as shown in the example below, proceed to the next step in
configuring the switch.
SFS-3504> show card
================================================================================
Card Information
================================================================================
admin oper admin oper oper
slot type type status status code
--------------------------------------------------------------------------------
2 fc4port4G fc4port4G up up normal
5* controllerIb12port4xDDR controllerIb12port4xDDR up up normal
================================================================================
Card Boot Information
================================================================================
boot boot boot
slot stage status image
--------------------------------------------------------------------------------
2 done success image-a:SFS_OS-2.10.0/build585
5 done success image-a:SFS_OS-2.10.0/build585
================================================================================
Card Seeprom
================================================================================
product pca pca fru
slot serial-number serial-number number number
--------------------------------------------------------------------------------
2 JBL07014804 JBL07014804 73-11051-02 68-2893-01
5 JAB111902Y9 JAB111902Y9 73-11049-02 68-2890-02
If the output of the show card command shows otherwise, enter the show diagnostic ? command to
determine whether or not a hardware failure has occurred. If the output shows a hardware failure, contact
your Cisco technical support representative.
determine whether or not a hardware failure has occurred. If the output shows a hardware failure, contact
your Cisco technical support representative.
Configuring the Cisco SFS 3504 Server Switch
This section assumes that you have verified the installation. At the end of the verification process, the
Cisco SFS 3504 Server Switch automatically obtains the IP address from Dynamic Host Configuration
Protocol (DHCP) if the DHCP server is configured. This section describes how to configure the
Cisco SFS 3504 Server Switch and includes the following topics:
Cisco SFS 3504 Server Switch automatically obtains the IP address from Dynamic Host Configuration
Protocol (DHCP) if the DHCP server is configured. This section describes how to configure the
Cisco SFS 3504 Server Switch and includes the following topics:
•
•
•
•
•
•