Cisco Systems SFS 3504 Manual De Usuario

This unit is intended for installation in restricted access areas. A restricted access area can be 
accessed only through the use of a special tool, lock and key, or other means of security. 
Statement 1017

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the 
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection 
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030

Ultimate disposal of this product should be handled according to all national laws and regulations. 
Statement 1040

This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. 
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The 
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2) 
while the housing is open, or both. Statement 1043

This product requires short-circuit (overcurrent) protection, to be provided as part of the building 
installation. Install only in accordance with national and local wiring regulations. Statement 1045

Use of controls, adjustments, or performing procedures other than those specified may result in 
hazardous radiation exposure. Statement 1057

The Cisco SFS 3504 Server Switch kit contains the following parts: 

One 5-slot multifabric server switch chassis

One InfiniBand switch card

One to four gateway modules, depending upon your configuration:

Ethernet gateway Product ID: SFS-3500-ENGW-1G 

Fibre Channel gateway Product ID: SFS-3500-FCGW-4G

Zero to three gateway blanking panels for I/O slots, depending upon your configuration

One or two power supplies, depending upon your configuration

Zero or one power supply blanking panel, depending upon your configuration