Crestron electronic CEN-UPS1250 Manual De Usuario

Descargar
Página de 40
Uninterruptible Power Supply 
 
Crestron CEN-UPS1250
 
Status and Informational Screens 
The following paragraphs describe the various status and informational screens that 
are available with the CDN-UPS1250. These are accessed by using the STATUS 
button on the front panel. 
NOTE:  For your convenience, you can set the unit to display any of the status 
screens as the “default” screen. The default screen is the screen that the system will 
return to once the preset time has expired for other screens that are being displayed. 
NOTE:  The display will revert to the default screen after about 30 seconds of 
inactivity. To change the default screen, first press the STATUS button until the 
desired screen is displayed. Then press and hold the STATUS button for 
approximately three seconds until the screen displays CURRENT SCREEN IS 
SAVED AS DEFAULT. 
The “SOURCE: XXXXXXX; EST. RUNTIME: XHRS” screen displays which type 
of source the unit is deriving power from (UTILITY, BATTERY or STANDBY). It 
also displays the EST. RUNTIME based on the power source and connected 
equipment load. In STANDBY, the unit does not provide power to the rear panel 
outlets. 
NOTE:  When the CEN-UPS1250 is connected to utility power, the electronics 
inside the unit are active. If the front panel power switch is turned off, the unit goes 
into STANDBY mode and shuts off power to the rear panel outlets but the display 
remains active. 
“SOURCE: UITLITY; EST. RUNTIME: XHRS” Screen 
SOURCE:UTILITY
EST.RUNTIME:2HRS
 
“SOURCE: BATTERY; EST. RUNTIME: XHRS” Screen 
SOURCE:BATTERY
EST.RUNTIME:118MIN
 
The “EST. RUNTIME: XHRS; FUEL: XXX%” screen displays the estimated 
runtime as EST. RUNTIME, as well as the FUEL capacity of the internal battery 
pack (as a percentage) based on the total load connected to the device. If the 
estimated runtime is less than one hour, the EST. RUNTIME will show in minutes. 
“EST. RUNTIME: XHRS; FUEL: XXX%” Screen 
EST.RUNTIME: 2HRS
FUEL: 100%
 
The “SYSTEM LOAD: XXXW; LOAD: XXX%” screen displays the value (load) of 
the connected equipment in Watts and as a percentage of the total allowable load 
24  
  Uninterruptible Power Supply: CEN-UPS1250 
Operations & Installation Guide – DOC. 6635A