Dakota Digital lat-nr200 Manual De Usuario
7. Insert the wires through the aluminum spacer, with one wire going
through each one of the outer holes. Ensure wires are not pinched to
avoid shorting! Slide the aluminum spacer over the stud thorough the
hole in the center of the spacer, shoulder side toward the back of the tail
light bezel.
avoid shorting! Slide the aluminum spacer over the stud thorough the
hole in the center of the spacer, shoulder side toward the back of the tail
light bezel.
8. Secure the aluminum spacer with the supplied #6 nut and lock washer.
9. Make sure the original lens gasket is in place and replace the tail light
9. Make sure the original lens gasket is in place and replace the tail light
lens. Tighten the screws down carefully.
MAN#650184