Zanussi zwh6120 p Manual De Usuario

6

Unpacking

All transit bolts and packing must be 
removed before using the appliance.

You are advised to keep all transit devices so 
that they can be refitted if the machine ever has 
to be transported again.

Important!

Very carefully 
remove the front 
polystyrene block 
(B) by gently pulling 
the polyethylene 
bag (1) downwards 
then (2) out, 
ensuring not to tear 
the bag (If fitted).

Using a spanner 
unscrew and 
remove the two rear 
bottom screws. 

Lay the machine 
on its back 
ensuring that the 
hoses are not 
crushed. Place 
one of the 
polystyrene angle 
packings under 
the machine. 

Some models are provided with a bottom 
cover that will be found inside the washing 
machine drum. After ensuring the polyethylene 
bags have been removed, follow below 
instruction:

Remove the 
polystyrene base, 
set the machine 
upright and unscrew 
the remaining rear 
screw. Slide out the 
relevant pin. 

Slide out the two 
plastic pins. 

Remove the 
polystyrene block 
(A) protecting the 
motor (If fitted).

Locate the 
bottom cover as 
shown in 
position (C).

(1). 

Then push the 
top end to lock to 
the bottom of 
washing machine.

(2). 

Cover all the open 
holes with the plugs 
which you can find in 
the bag containing 
the instruction 
booklet.

Positioning

Install the machine on a flat hard floor. 

Make sure that air circulation around the 
machine is not impeded by carpets, rugs etc. 

Check that the machine does not touch the 
wall or cupboard units.