Cisco Systems 7902G Manual De Usuario
Appendix A Additional Configuration Methods, Parameters, and Procedures
Configuration Parameters
A-16
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Tone Parameters
describes the tone parameters that you can configure through a phone’s
profile file or through its Tone Parameters web page.
Nprintf
IP address and port of a
server to which
Cisco IP Phone
troubleshooting messages
are sent.
server to which
Cisco IP Phone
troubleshooting messages
are sent.
Enter the extended IP address of the server to which
troubleshooting messages are sent and collected in a
log file.
troubleshooting messages are sent and collected in a
log file.
The default value is 0, which specifies that no
messages are sent.
messages are sent.
Note
To collect troubleshooting messages, the
prserv.exe tool must be running on the server
specified with this parameter.
prserv.exe tool must be running on the server
specified with this parameter.
For more information about using Nprintf and
preserv.exe to collect troubleshooting information,
see the
preserv.exe to collect troubleshooting information,
see the
.
TraceFlags
Enables specific trace
features.
features.
Bit map
Bit 0–31—Reserved for future use.
Should be set to zero (0). The default setting is
0x00000000.
0x00000000.
1.
CDP = Cisco Discovery Protocol
Table A-1
Network Parameters (continued)
Parameter
Description
Usage