Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Fujitsu
  4. C120-E361-04EN
  5. Manual De Usuario

Fujitsu C120-E361-04EN Manual De Usuario

Descargar
Página de 36
C120-E361-04EN
1-5
1.3  RCI Setup
4
Connect the main unit and I/O units with RCI cables (see 
Connect an RCI branching connector to each of the RCI ports, and connect them with 
RCI cables by using a daisy-chain connection.
Connect an RCI terminating resistor to the branching connector at either end of the 
5
Turn on the AC input to all the RCI device which are in the RCI connection.
6
Execute the setrci -c set command to make the settings of the host node.
Since the main unit is the first unit, host_no is 1.
7
Execute the setrci -c initconfig command to configure the RCI.
8
Execute the setrci -c stat command to display the RCI status.
9
Verify that all the RCI device in the RCI connection are incorporated.
XSCF> setrci -c init
The command completed successfully
XSCF> setrci -c set 1
The command completed successfully
XSCF> setrci -c initconfig
The command completed successfully
XSCF> setrci -c stat
HOST
 address 000101ff
 Active
LIST
 address     pwr  alm   I/F   sys-phase   ctgry  dev-cls sub-cls tm-out
 000101ff   OFF   -    ACT   power-off   host   0001    0b      - 
 003001ff   OFF   -    ACT   power-off   disk   0400    04      - 
 003002ff   OFF   -    ACT   power-off   disk   0400    04      -
The command completed successfully