Bunn CDS-3 Manual De Usuario

23

FIG. 17 LAMP CORD ASSY

P1891

Location:

The lamp cord assembly is located in the top of 

the dispenser.
Test Procedures:

1.  Disconnect the dispenser from the power source.

2.  Unplug the lamp cord assembly from lamp cord 

connector assembly.

3.  Check for continuity across the tip of the cord as-

sembly and the housing. Continuity must not be 

present when the lamp is removed.

If continuity is present as described, the cord assembly 

is operating properly.
If continuity is not present as described, replace the 

cord assembly.
Removal and Replacement:

1.  Disconnect  the  lamp  cord  assembly  from  the 

lamp cord connector assembly in the top of the 

dispenser.

2.  Open the dispenser door and remove the five screws 

securing the rear cover to the door.

3.  Disconnect the lamp cord assembly from the lamp 

holder/socket  assembly  and  set  the  rear  panel 

aside.

4.  Cut the terminals off of the lamp cord assembly.

5.  Remove  lamp  cord  assembly  from  the  door  as-

sembly and discard.

6.  Push new lamp cord wires through the holes on 

the top of the door assembly.

7.  Strip the wires from the new lamp cord approxi-

mately .281”.

8.  Using the two terminals supplied, crimp the new 

terminals to the lamp cord assembly and connect 

them to the lamp holder/socket assembly wires.

9.  Reinstall the rear panel to the door assembly.

10. Close the door.

11. Plug-in the new lamp cord assembly to the lamp 

cord connector assembly on top of the dispenser.

12. Refer to Fig. 18 when reconnecting the wires.

FIG. 18 LAMP CORD WIRES

P1926

BLK to WHI

at Lamp Holder

BLK to BLK

at Lamp Holder

29793 061599