Cisco Systems 7301 Manual De Usuario

During the boot process, observe the system LEDs. The STATUS LED comes on immediately as amber, then turns to 
green when the Cisco IOS is booted. Port adapter LEDs go on and off irregularly.

Observe the initialization process. The port adapter ENABLED LEDs go on when initialization is completed and the 
console screen displays a script and system banner.

Before configuring the router, determine whether or not you want to use a management tool such as Cisco Security Device 
Manager. 

Cisco Security Device Manager (SDM), version 1.1, is an optional Java-based device-management tool that allows you to 
configure LAN interfaces, routing, Network Address Translation (NAT), firewalls, Virtual Private Networks (VPNs), and other 
features without knowledge of the Cisco command-line interface (CLI). You can configure features such as Access Control Lists 
(ACLs), routing protocols, and other options using SDMs advanced mode.

You will need to use CLI commands to configure several features that SDM does not support. SDM does not support 
the following features: WAN configuration, Gigabit Ethernet (GE) interfaces, AA client, EZ VPN server, QoS,SSHv2, 
DHCP server configuration options, and usability enhancements.

SDM is preinstalled on your routers Flash Disk or CompactFlash Disk when it is ordered as part of a VPN bundle or as part of 
a 7xxx VPN bundle. If your router did not ship with SDM preinstalled, you can download a free copy from the Software Center 
at Cisco.com at http://ww.cisco.com/kobayashi/sw-center/index.shtm. Because SDM uses a GUI, it requires that you access it 
from a PC using a supported web browser. Go to the Security Device Manager (SDM), Version 1.1 User Note for the 7xxx 
Routers for more information.

If you do not plan to use AutoInstall, do not connect the router’s serial (WAN) cable to the channel service unit/data service unit 
(CSU/DSU). If the WAN cable is not connected, the router boots from Flash memory and goes automatically into the setup 
facility.

You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.

If the serial (WAN) cable is connected to the CSU/DSU and the router does not have a configuration stored in NVRAM, the 
router attempts to run AutoInstall at startup. The router may take several minutes to determine that AutoInstall is not set up 
to a remote TCP/IP host. Once the router determines that AutoInstall is not configured, it defaults to the setup facility.

RJ-45 EN (0/2) RJ-45 enable (0/2)

Green

In the Power Up state, 
the LED is On

No, remains 
constantly on

STATUS

System status

Amber while the system boots

Green when the system is 
operational

—

In the Power Up state, 
the LED is On

No, remains 
constantly on