Cisco Systems 7301 Manual De Usuario

For a workbench or tabletop installation, verify the following before installing the router:

The router is off the floor and has adequate ventilation.

An adequate chassis ground (earth) connection exists for the router.

The router has at last 3 inches (7.62 cm) of clearance at the inlet and exhaust vents (sides of router).

The router has 19 inches (48.3 cm) clearance at the front and rear to allow for CompactFlash Disk, SFP Gigabit Interface 
Converter (GBIC) module, and port adapter replacement or installation, or to access cables or equipment.

The port adapter filler panel is installed if a port adapter is not installed. The slot must not be empty.

For cable-management bracket installation instructions, see page 9.

Before you begin the rack-mounting tasks, decide whether or not you want to front- or rear-mount the chassis, decide whether 
or not you want to attach the cable-management bracket, and determine the type of rack—four-post or two-post—that you will 
be using.

This section provides installation instructions for the Gigabit Ethernet SFP Gigabit Interface Converter (GBIC) module. It does 
not ship installed. 

Port adapter

Auxiliary port

Port adapter latch

Console port

RJ-45 port GE 0/0

CompactFlash Disk ejector button

Gigabit Ethernet SFP GBIC port 0/0

Ground for ESD wrist strap with banana jack

RJ-45 port GE 0/1

Alarm port 

Gigabit Ethernet SFP GBIC port 0/1

Power switch

RJ-45 port GE 0/2

CompactFlash Disk slot

Gigabit Ethernet SFP GBIC port 0/2

Power connector

ALARM

RJ45 EN

LINK

TX

RX

GBIC

GIGABIT ETHERN

ET 0/2

RJ45 EN

LINK

TX

RX

GBIC

GIGABIT ETHERN

ET 0/0

RJ45 EN

LINK

TX

RX

GBIC

GIGABIT ETHERN

ET 0/1

SLOT 1

CONSOLE

AUX

COMPACT

FLASH

STATUS

100-240V

, 2A, 50/60 H

z

24V=9A, 48 - 60V

=5A

ENABLED

RX CELLSRX CARRIER

RX ALARM

ATM 

80265

B

A