Bunn FMD-3 Manual De Usuario
23
FAN
FIG. 13 FAN
P1436
Location:
The fan is located inside the dispenser housing
on the right rear of the dispenser base plate.
Test Procedures:
1. Disconnect the dispenser from the power source.
2. Disconnect the black and white wires from the
1. Disconnect the dispenser from the power source.
2. Disconnect the black and white wires from the
fan terminals.
3. With a voltmeter, check the voltage across the
black and white wires. Connect the dispenser to
the power source. The indication must be:
a) 120 volts ac for two wire 120 volt, three wire
120/208 volt and 120/240 volt models.
b) 240 volts ac for two wire 240 volt models.
the power source. The indication must be:
a) 120 volts ac for two wire 120 volt, three wire
120/208 volt and 120/240 volt models.
b) 240 volts ac for two wire 240 volt models.
If voltage is present as described, replace the fan.
If voltage is not present as described, refer to
If voltage is not present as described, refer to
Wiring
Diagrams and check the dispenser wiring harness.
SERVICE (cont.)
J4
J1
J2
J3