Barco E-2320 C (SE) Manual De Usuario

Display installation

45

1. Connect the display’s USB upstream connector to the USB 

port of the PC by means of a USB cable.

2. Connect any USB device to any of the display’s USB 

downstream connectors.

Figure 15

• Bind the cables in the connector compartment together with 

the cable tie inside the connector compartment. 

• Put the connector compartment cover back on the display. Pay 

attention that the signal cables are positioned under the bulge 
in the cover.

• Push the cables into the clips on the rear of the tilt & swivel 

foot.

• Bind the cables together above and under the foot, by means 

of the 2 velcro strips attached to the inside of the foot cover 
(packed inside the accessory box).

• At last, put the foot cover back in place.