Nero nero wave editor 2 Manual De Usuario
Nero Wave Editor
Effects
• 35
7.4 Dynamics
The dynamic processor changes the amplitude, i.e. the dynamic part of an audio
file. This is then limited, compressed or increased. This setting is made via
curve control; if the line runs from the lower left corner to the upper right-hand
corner, the amplitudes of the input (X) and output signals (Y) are the same at
each point. Editing this line will change the output in relation to the input.
file. This is then limited, compressed or increased. This setting is made via
curve control; if the line runs from the lower left corner to the upper right-hand
corner, the amplitudes of the input (X) and output signals (Y) are the same at
each point. Editing this line will change the output in relation to the input.
1. Open the desired file.
2. Select the 'Dynamic Processor' command in the 'Tools' menu.
2. Select the 'Dynamic Processor' command in the 'Tools' menu.
3. Place the mouse cursor on that part of the green line that you wish to alter –
a white square will appear at the place where you click the mouse – and drag
the square to the position desired.
Repeat this procedure for all the sections selected.
the square to the position desired.
Repeat this procedure for all the sections selected.
You can remove a dynamic position by clicking on the chosen square with the
right-hand mouse button.
right-hand mouse button.
In addition, you can also change the reaction time of the dynamic processor
using the 'Attack time' and 'Release time' round buttons.
using the 'Attack time' and 'Release time' round buttons.