Crestron hbk-6000 smk-6000 Manual De Usuario

Hatch Back and Swivel Mount Kits 

 

Crestron HBK-6000 & SMK-6000

This section provides an installation procedure for each kit. The only tools required 
are #1, #2, and #3 Phillips screwdrivers. 

To attach the HBK-6000 Hatch Back Kit to the TPS-4500, -5000, or -6000 
Touchpanel, refer to the illustration below and perform the procedures that follow. 

Metal Bracket

Plastic Cover

Mounting Holes (4)

A

A

Openings For 

Touchpanel 

Rear Feet (2)

Screws (4)

1.  If necessary, use the touchpanel position lock buttons to adjust the display 

to the maximum (most vertical/upright) angle. 

2.  Place the touchpanel face down on a padded surface to prevent damage to 

the display screen. 

3.  Remove the four screws from the bottom rear of the touchpanel that 

correspond to the mounting holes (A) in the metal bracket. 

4.  Position the metal bracket on the touchpanel base (mounting holes should 

align, touchpanel feet should protrude through openings provided, and 
standoff posts should point toward the touchpanel). Secure the metal 
bracket to the touchpanel using the four screws removed in step 3.  

5.  With the touchpanel in its normal position, make certain cable connections 

are secure, put the plastic cover in position with the cables routed through 
the rear opening. Secure the cover to the metal bracket using the four  
# 4-40X 3/16-inch screws supplied. 

To attach the SMK-6000 Swivel Mount Kit to the TPS-4500, -5000, or -6000 
Touchpanel and install the assembly on a suitable mounting surface, refer to the 
following illustrations and perform the associated procedures. 

1.  Prepare the mounting surface using the template provided with the kit. The 

center hole for the swivel assembly should be 2.5-inches minimum;  
2.6-inches maximum. Make certain to observe the “FRONT” position when 
drilling the four holes for the swivel assembly standoff posts. 

2.  If necessary, to prevent errors when reconnecting, label and disconnect any 

cables connected to the touchpanel. 

3.  If necessary, use the touchpanel position lock buttons to adjust the display 

to the maximum (most vertical/upright) angle. 

•  Hatchback and Swivel Mount Kits:  HBK-6000 & SMK-6000