Fujitsu plasmavision p42hta51e Manual De Usuario

The currently selected mode will appear.

Each time you press 

, a different Screen Size 

appears.  The sequences used are as follows:

When you are in a Video input mode

When you are in an RGB input mode

* Depending on the type of signal, some aspects 

may not be selected.

* You can also use the buttons 

on the display’s control 
panel to perform these steps.

Normal mode

Wide1 mode

Normal

Wide

Zoom

• When the WIDE mode is set to “Normal”, and pictures are shown for an extended time, a residual image or “burn-in” may be created. The burn-in 

may occur at the boundary where the left and right borders of the picture meet the vertical bars. To reduce the chance of “burn-in” when watching in 
the “Normal”, we recommend you set the “Background” to “Light Gray”.  (See P. E-28)

• When a residual image was created, it is reduced by using the “White Screen” settings. Note that there may also be cases when it can not be 

recovered completely. (See P. E-28)

• A variety of Screen Sizes are available with this display.  Remember that if you select a mode with an aspect ratio (ratio of frame width to frame 

height) different from that of the TV program or video media, the pictures will appear differently than if you had selected a mode having the same 
aspect ratio.

• Showing a movie or similar premium event at a different aspect ratio from its original one at any event site, restaurant, or bar for profit-making 

purposes or for a public audience may constitute a copyright infringement.
For films, try to select a mode having the same aspect ratio as the original picture; this enables the director’s original intentions to be preserved.

• See P. E-22 for how to adjust the picture size and position.

01_E_7473.book  16 ページ  ２００６年９月６日　水曜日　午後２時３６分