Furuno fmd-1712 Manual De Usuario
2
1.2 Turning the Remote Display
On/Off
On/Off
The [POWER] key turns the remote display
on/off.
on/off.
1.3 TX Key
The [TX] key functions to toggle the radar
picture and stand-by condition. Note that
the remote display cannot control the
transmit and standby functions of the radar.
picture and stand-by condition. Note that
the remote display cannot control the
transmit and standby functions of the radar.
The main radar and remote display do not
operate jointly unless a key among RANGE,
GAIN or STC is operated.
operate jointly unless a key among RANGE,
GAIN or STC is operated.
1.4 LCD Tone and Brilliance
1. Press the [TONE] key. The dialog box
shown in Figure 1-1 appears.
TONE: 12
LOW
HIGH
BRILL: 3
LOW
▼
▲
HIGH
▲
▲
Figure 1-2 Dialog box for adjustment of
brilliance and tone of LCD
2. Press or to adjust tone (setting
range: 0-27): or to adjust brilliance
(setting range: 0-9).
(setting range: 0-9).
Note: The dialog box for adjustment is
automatically erased when there is no
Omnipad operation for 10 seconds.
Omnipad operation for 10 seconds.
1.5 Operation Conventions
The main radar (Model 1712 or 1622) must
be powered and transmitting to display the
radar picture on the remote display. If the
main radar is off, in standby, or there is
antenna trouble, the remote display shows
the indications HD-SIG-MISS and BP-SIG-
MISS.
be powered and transmitting to display the
radar picture on the remote display. If the
main radar is off, in standby, or there is
antenna trouble, the remote display shows
the indications HD-SIG-MISS and BP-SIG-
MISS.
RANGE, GAIN and STC controls
•
The RANGE, GAIN and STC controls are
commonly set. (Other controls may be
independently set.) That is, when one of
those controls is adjusted, the main radar
or remote display receiving the command
is automatically set accordingly. STC and
GAIN adjustment methods (automatic
and manual) are also commonly
switched.
commonly set. (Other controls may be
independently set.) That is, when one of
those controls is adjusted, the main radar
or remote display receiving the command
is automatically set accordingly. STC and
GAIN adjustment methods (automatic
and manual) are also commonly
switched.
•
The last-operated control among GAIN,
RANGE and STC takes priority when the
main radar and remote display are
operated simultaneously. Therefore, if
your command was not accepted the
reason may be simultaneous operation.
RANGE and STC takes priority when the
main radar and remote display are
operated simultaneously. Therefore, if
your command was not accepted the
reason may be simultaneous operation.
•
Range is commonly set regardless of
range setting on the menu of the main
radar and remote display. For example,
the remote display selects the 2 nm range.
The main radar also sets the 2 nm range
even if it is turned off on its menu.
range setting on the menu of the main
radar and remote display. For example,
the remote display selects the 2 nm range.
The main radar also sets the 2 nm range
even if it is turned off on its menu.