Furuno FR-2125V Manual De Usuario

6. If you selected NO. 2 VRM in step 3 above, make sure that the No. 2 VRM is active and

adjust the spacing between the index lines by operating the VRM control.

7. Press the [RADAR MENU] key to close the FUNCTIONS 2 menu.

You can mark any reference points, prominent target or a point of particular interest using
the origin mark feature. These marks (max 10) are geographically fixed, that is, ground
stabilized. To display the origin marks, heading signal and position data are required.

1. Using the trackball, place the cursor (+) at a point where you want to place a reference

mark.

2. Press the [RADAR MENU] key to show the FUNCTIONS 1 menu.

3. Press the [3] key. The origin mark appears at the cursor position of which range and

bearing are indicated at the screen center.

4. To measure the range and bearing to a target of interest from the origin mark, move the

cursor to the target of interest. Then, the range and bearing from the origin mark to the
target are shown at the screen center.

5. To enter another origin mark, press the [ENTER] key and the [3] key in the FUNC-

TIONS 1 menu. Place the cursor where you want to place the origin mark, then press
the [3] key.

6. To erase the origin mark, select the origin mark number in the FUNCTIONS 1 menu by

pressing the [ENTER] key and the [3] key repeatedly, and then press the [3] key once
again.

000

010

020

030

040

050

060

070

080

090

100

110

120

130

140

150

160

170

180

190

200

210

220

230

240

250

260

270

280

290

300

310

320

330

340

350

1

Cursor

Origin
Mark

Range and bearing
from origin mark to
cursor

0.101SM

254.3

°

T

01 

− 

>  +

Figure 1-39 Origin mark