briggs--stratton 5900861 Manual De Usuario

 1.  Park the tractor on a smooth, level surface such as a 

concrete floor.  Disengage the PTO, engage the parking 
brake, turn off the engine, and remove the ignition key.

 2.  Remove the PTO drive belt (see MOWER BELT 

REPLACEMENT for removal instructions).

 3.  Remove the hardware that secures the clutch anchor 

pad to the PTO clutch.

 4.  Loosen the nut on the spring anchor eyebolt (G, Figure 

47) to release the majority of the belt tension.  Use 
caution and remove the nut to completely release the 
tension.

 5.  Remove the old belt and replace it with the new one.  

Make sure the V-side of the belt runs in the grooves of 
the crankshaft pulley and pump pulleys (B & C).

 6.  Reinstall the spring anchor eyebolt (G) into the anchor 

tab and loosely fasten the nut.  Adjust the anchor 
eyebolt until a measurement of 8-3/8” (21,2 cm) is 
achieved from the outside if the spring hooks.  Tighten 
nut.

 7.  Reinstall the clutch anchor pad to the PTO clutch and 

secure with the hardware previously removed.

 8.  Reinstall the PTO drive belt.

STORED ENERGY DEVICE:  Improper release 
of the belt tension spring can result in personal 
injury.  Use extreme caution when removing 
this spring.

Regular Maintenance

Not 

for  

Reproduction