Bulldog Security deluxe 500 Manual De Usuario

11

The transmitter can be used as a remote panic switch to

manually trigger the alarm in case emergency.

1. Press and hold the   button for 3 second. The alarm will

immediately sound.

2. During “Panic Mode”, the normal function of this trans-

mitter button will be suspended. The   and   buttons can be

used to lock and unlock the doors (if the option is installed), however

once the   button is pressed, the vehicle’s starter disable

device, (if installed) will be enable allowing the vehicle to start.

3.  To stop the “Panic Mode”, press and hold the   or   buttons on the

transmitter again for 3 seconds, if any transmitter button other than the

 or   button is pressed and released, the “Panic Mode” will be turned

off immediately.

4. If the button is not pressed, the alarm will automatically stop after 30

seconds.

When you want to check the system’s present status through

the LCD screen, Press the transceiver   button (2) times,

within 3 seconds press the  (SET) button. It responds with

one melody sound, the LCD screen should be illuminated.

The alarm has a unique feature that will turn “ON” your vehicles dome light

as follows:

1. Upon disarming, the interior dome light will remain “ON” for 30 seconds.

2. If the vehicle is intruded, the interior dome light will flash for the same

duration as the siren.

off the dome light.

If the vehicles door locks have been interfaced to the security systems

keyless entry, the system will automatically lock the vehicle's doors when

the ignition is turned “ON” and will unlock the vehicle’s doors when the

ignition is turned “OFF”.