Cisco Systems 827-4v Manual De Usuario

Copyright © 1999-2005 Go2Call.com, Inc. and/or its suppliers.  All rights reserved.  “Go2Call” and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call’s permission. Other product 
and company names herein may be the trademarks of their owners. This document is provided “as-is” by Go2Call.com, Inc. for the user’s internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or 
complete and all use of such information is solely at the user’s risk.  All warranties disclaimed.

The following example uses Cisco 827-4V gateway with four FXS/FXO ports and SIP protocol.  Prior to 
the configuration, you must obtain:
  -IP address and Internet service from your local ISP provider
  -Account with Go2Call and up to 4 different PIN number
  -Cisco 827-4V with all necessary voice cards and modules

  STEP 1 

  Use the blue console cable and DB-9 adaptor.  Connect one end of the cable to the Console port on the  
   

router, and the other end with DB-9 adaptor to COM 1 or COM2 port on PC. 

  Start any terminal program on the PC (for example, Hyper Terminal).  Use the following terminal Settings:

 

 

 

 

9600 baud rate

 

 

No parity

 

 

8 data bits

 

 

1 stop bot

 

 

No flow control

 

This will power up the router.  You will know it has booted up successfully if your receive this prompt:

 

 

 

 

Router>