Chevrolet impala 2000 Manual De Usuario

To determine if your garage door opener has this
“rolling code” feature, press the appropriate button on
the universal transmitter that was programmed. If the
red light flashes rapidly for one to two seconds, then
turns solid, your garage door opener has this feature.

To program a garage door opener with the rolling code
feature, do the following:

1. Program your hand

-

held transmitter to the universal

transmitter by following the steps provided under
“Programming the Transmitter” earlier in this section.

2. Remove the cover panel from the garage door opener

receiver. It is located near the garage door opener motor.

3. Locate the training button on the garage door opener

receiver. The exact location and color will vary
among brands.

4. Press the training button on the garage door opener

receiver for one to two seconds.

5. Return to your vehicle and press the programmed

button on the universal transmitter until the red light
flashes rapidly (about two seconds).

6. Release the button, then press it again to confirm it

was programmed to the garage door opener receiver.

You may now use either the universal transmitter or the
hand

-

held transmitter to open your garage door. If you

still have difficulty in programming and require
assistance, please call 1

-

800

-

355

-

3515.

To erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.

Accessories for the universal transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1

-

800

-

355

-

3515.