Cisco Systems 1760 Manual De Usuario
6
Figure 4
Attaching the Cable Guide to the Router
5
Installing WIC/VIC Cards
The router has four card slots that hold Cisco WICs and VICs. Either one or two WICs may be installed, with the remaining
slots holding VICs, as desired. If no WICs are present in the slots, up to four VICs may be installed. Each WIC has one or two
WAN ports, and each VIC has two or more voice ports. This section describes the procedure for installing a WIC or a VIC in
the router.
slots holding VICs, as desired. If no WICs are present in the slots, up to four VICs may be installed. Each WIC has one or two
WAN ports, and each VIC has two or more voice ports. This section describes the procedure for installing a WIC or a VIC in
the router.
Note
For details on specific WICs and VICs, on how to connect a WIC to the WAN line or a VIC to the telephone and fax
line, and on how to configure the interface with Cisco IOS software, refer to the Cisco WAN Interface Cards Hardware
Installation Guide that came with the cards.
line, and on how to configure the interface with Cisco IOS software, refer to the Cisco WAN Interface Cards Hardware
Installation Guide that came with the cards.
Safety Information
This section lists safety warnings that you should be aware of before installing WICs or VICs in the router. To see translated
versions of these warnings, refer to the Regulatory Compliance and Safety Information for the Cisco 1700 Routers document
that came with the router.
versions of these warnings, refer to the Regulatory Compliance and Safety Information for the Cisco 1700 Routers document
that came with the router.
Warning
Before working on a system that has an on/off switch, turn off the power and unplug the power cord.
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment.
Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and
watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld
the metal object to the terminals.
watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld
the metal object to the terminals.
Warning
Before opening the chassis, disconnect the telephone-network cables (from the card) to avoid contact with the
telephone-network voltages.
telephone-network voltages.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Cisco 1700
Series
10/100 ETHE
RNET
AUX
CONSOLE
PVDM 0
OK
OK
PWR
1
0
SLOT 0
OK
PVDM 1
OK
MOD
OK
1
0
SLOT 1
OK
LINK
100
FDX
ACT
COL
1
0
SLOT 2
OK
1
0
SLOT 3
OK
65286
Cable guide screw