Dynex dx-rcrt20-09 Manual De Usuario
Using your TV
19
Skipping unwanted channels
After saving channels into memory, you can eliminate unwanted channels from memory so
that only the channels you want to watch are selected with the CH+ or CH– buttons.
that only the channels you want to watch are selected with the CH+ or CH– buttons.
To delete a memorized analog channel:
1 Tune to the channel you want to delete.
2 Press MENU on the TV or remote control. The on-screen display (OSD) opens.
3 Press VOL+ or VOL– to select CHANNEL, then press CH –. The CHANNEL menu opens.
4 Press CH + or CH – to select SKIP, then press VOL+ or VOL– to select ON.
2 Press MENU on the TV or remote control. The on-screen display (OSD) opens.
3 Press VOL+ or VOL– to select CHANNEL, then press CH –. The CHANNEL menu opens.
4 Press CH + or CH – to select SKIP, then press VOL+ or VOL– to select ON.
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
OFF.
5 Press MENU one or more times to close the OSD.
To delete a memorized digital channel:
1 Tune to the channel you want to delete.
2 Press CH.LIST to open the CHANNEL LIST screen.
3 Press CH + or CH – to select SKIP, then press VOL+ to select ON.
2 Press CH.LIST to open the CHANNEL LIST screen.
3 Press CH + or CH – to select SKIP, then press VOL+ to select ON.
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
OFF.
4 Press MENU one or more times to close the OSD.
Selecting a different signal source
This TV has one group of AV input terminals, an S-VIDEO input terminal, and set of
Component input terminals to enable connection to a DVD, VCR, or other video equipment.
For information on connecting your TV to other video equipment, see “Connecting to other
equipment” on page 16.
Component input terminals to enable connection to a DVD, VCR, or other video equipment.
For information on connecting your TV to other video equipment, see “Connecting to other
equipment” on page 16.
To select a different signal source:
• Press INPUT repeatedly to cycle through the available input sources. The input sources
will be shown on the screen as they are selected.
Note: The S-VIDEO input uses the same circuit as
VIDEO
. If both S-VIDEO and
VIDEO
inputs
are connected, the S-VIDEO signal overrides the
VIDEO
signal and S-VIDEO is shown on the
screen. To watch the
VIDEO
input, disconnect the S-Video cable.
To watch TV again, press INPUT until the TV program is shown on the screen.